Welcome To PG Racing - Hoermann HT2
Posted by PG Racing
www.pgracing.co.uk
The HT2 is completely conceived for the hard running enterprise. Its numerous success in the D-Cup and also when many European running makes the HT2 desire-who-tests RC-model on a scale 1:6. Numerous details of the vehicle were developed further continuously regarding durability and easy to service. The following equipment characteristics set yards within the Off-road range:
The sturdy chassis from 4mm aluminium with the
wheel base 510mm, the front axle completely manufactured from
aluminium, the sturdy wishbones with very good adjustment
possibilities, the rear axle with a firmly given toe-in, the
upper wishbone, completely manufactured from aluminium, is all
adjustable.
The aluminium knuckles with brake admission permit the assembly
of the usual brake systems. The drive unit with fixed connection
between parts, intermediate shaft and engine mounting plate
provide for a sufficient stability around chassis also from
Tuning motors without loss to the rear axle further to give.
The very durable gears in connection with the
hardened steel gear wheels provides for the correct propulsion.
Further details is the Zenoah G260RC engine with a RN-Tuning off
Road filter, as well as a carbon fibre servo plate for 3 Servos.
The strong mechanical transmission brake and the ball drive with
dust seals, manufactured from steel.
A muffler made of high-grade steel. The light run ball bearings,
a very stable and durable differential. The nearly
indestructible rubber spoiler, and the just as durable rims with
aluminium ring reinforcement.
The materials in detail:
Aluminum Parts:
Chassis
Axle Casings
Wishbone's
Knuckle's
Shock Absorber Tower
Shock Absorber
Stop Bolt
Servo Saver Down Part
Connecting piece for A + B Axle Casing
Wheel Driver
Thrust washer for plastic gear wheel
Engine Flange
Transmission Flange
Engine brake actuating disk
Differential Housing
Side parts Differential - Up Rights
Rear Shock Tower
Steel Parts:
Wishbone Pins
Steel ball for steering linkage
Tie Rods
Hardened gear wheels
Clutch bell
High-grade steel elbow union
High-grade steel muffler
Drive Shafts
Ball Drive
Knockout spindle for ball drive
Plastic parts:
Spoiler from special plastic, very flexibly.
Side parts spoiler owner
Front Bumper
Side Tub
Servo saver lower part
Plastic joints for the steering element
Main gear wheel from Delrin
Fuel Tank
Boots ball drive
Receiver box
Rims
Retaining plate
Carbon fibre servo plate
Optional Tuning:
Hydraulic brakes front rear axle
Carbon fibre brake disks
Engine quick-change unit
Spoiler attachment for rubber spoiler
Steel wheel driver 9,5mm with pins
Tie rod safety device
Personnel transponder Mount
Check valve for tank ventilation
Adjustable spoiler
Carbon fibre
Tuning muffler